ORIGINAL BEVEL QUARTZ BANGER - 90° DEGREE | YL-CLOSEOUT
ORIGINAL BEVEL QUARTZ BANGER - 90° DEGREE | YL-CLOSEOUT
- Outer Diameter - 25mm
- Thickness - 3mm
- Edge - Bevel
- 90° Frosted Joint
- Butane Torch Recommended
- Recommend Carb Cap(s) - HONEY BUBBLE CAP 25MM & HONEY HIVE BUBBLE CAP
Back to basics usually means pulling out the rolling paper, but in this case, it's all about quartz. The original style Honeybee Herb Bevel brings a hint of class to your rig with a 25 mm outer diameter and a 3mm thickness that gives additional protection against falls. not to mention the option of a classy frosted joint finish.
This unit comes in designs of 90° and 45° angles banger with Male or Female joints ranging in sizes of 10mm, 14mm, and 18mm. As with all our products, we recommend the use of a butane torch rather than propane to guarantee being set for the long haul.
Add our most demanding 2 Carb Cap, Honey Bubble Cap 25mm & Honey Hive Bubble Cap with this dab rig banger to double your dab experience
Authorized retailer
We source Honeybee Herb direct, not through resellers. Real product, real warranty, real provenance.
Quartz banger questions
How do I season a new quartz banger?
Heat to red with a torch, let it cool to room temp completely (5+ minutes), then dab. Repeat 2–3 times. This prevents the new quartz from absorbing terps unevenly on first use.
What temperature should I dab at?
Low-temp dabs (450–550°F) preserve flavor; high-temp dabs (650°F+) give bigger clouds but burn off terps. Most flavor chasers heat to red, then wait 30–45 seconds before dabbing.
How do I clean it?
Q-tip while still warm — much easier than cleaning cold quartz. For deep buildup, soak in 91%+ isopropyl alcohol overnight. Don't over-torch trying to burn off chazz; that just makes it worse.
Why does my banger have white spots after a few uses?
That's chazz — quartz degradation from over-heating. Once it starts, it doesn't come off. Lower your heat, Q-tip after every dab, and replace the banger when it gets bad enough to affect flavor.
Bong & rig questions
How much water should I put in?
Enough to cover the downstem slits by about half an inch. Too little = no filtration; too much = splashback into your mouth. Test by inhaling gently before lighting.
How do I clean it?
Empty water after every session. Deep clean weekly with 91%+ isopropyl alcohol and coarse salt — see our 7-step bong cleaning guide. Don't pour boiling water on cold glass — borosilicate is heat-resistant, not heat-proof.
What's a percolator and which is best?
A percolator is the part that diffuses smoke into water for cooler, smoother hits. Showerhead, tree, honeycomb, and recycler are common. Recycler is the smoothest; showerhead is the most balanced. Read the bong shape guide for the full breakdown.
Will my existing bowl/banger fit?
Match joint size and gender (male/female). Most modern rigs use 14mm female. Read the joint sizes guide if unsure.