HONEY WELL QUARTZ BANGER - 45° DEGREE | YL
HONEY WELL QUARTZ BANGER - 45° DEGREE | YL
SPECS
- Outer Diameter - 25mm
- Thickness - 2.5mm
- Edge - Bevel
- 45° Frosted Joint
- Regular Weld
- Compatible Pearl Sizes - 2mm, 4mm, 6mm
- Recommended Inserts - MARBLE SET or GLASS MUSHROOM PILLAR SET
- Butane Torch Recommended
Also Known As
- Honey Well Xl Slurper Banger
- Honey Well Blender Style Banger
Description
Have you been searching for a Quartz Banger that packs a little more than other dab rig bangers? The HoneyWell Quartz Banger is definitely a top dog.
Heat your Honey Well with a dab torch . When heating is finished, allow the nail to cool to your desired heat, then place your product into the bottom dish and top with the largest marble.
Once the chamber is sealed, the air that is pulled through the angled holes in the side of the bottom chamber will cause a vortex to spin the capsule, pillar, or pearl in the bottom.
Don't delay! Grab a Honey Well today!
Recommendation
Use a Glass Mushroom Pillar Set Or Marble Set for the best experience with this Honey Well Banger.
Perfect Temperature Guide - Read this blog and master the perfect temperature for you and your Honey Well
Butane Vs. Propane - Choose the right one and get the most out of your experience!
FAQs
How Many Turbine Holes Does This Honey Well Quartz Banger Have?
The Honeywell was designed with two turbine auto spinner holes for maximum airflow and vaporization efficiency.
Will My Inserts Still Spin At A 45 Degree Angle?
Yes, as long as airflow isn't restricted and there is a proper fit and seal with your carb cap, your inserts should still move at 45-degree angles.
Authorized retailer
We source Honeybee Herb direct, not through resellers. Real product, real warranty, real provenance.
Quartz banger questions
How do I season a new quartz banger?
Heat to red with a torch, let it cool to room temp completely (5+ minutes), then dab. Repeat 2–3 times. This prevents the new quartz from absorbing terps unevenly on first use.
What temperature should I dab at?
Low-temp dabs (450–550°F) preserve flavor; high-temp dabs (650°F+) give bigger clouds but burn off terps. Most flavor chasers heat to red, then wait 30–45 seconds before dabbing.
How do I clean it?
Q-tip while still warm — much easier than cleaning cold quartz. For deep buildup, soak in 91%+ isopropyl alcohol overnight. Don't over-torch trying to burn off chazz; that just makes it worse.
Why does my banger have white spots after a few uses?
That's chazz — quartz degradation from over-heating. Once it starts, it doesn't come off. Lower your heat, Q-tip after every dab, and replace the banger when it gets bad enough to affect flavor.